Front fork
The front fork holds the castor wheel and absorbs the shocks from the ground while you travel. A bent or worn fork is immediately noticeable in the steering.
We carry front forks from Mobilex in lengths from 92 to 180 mm and widths from 39 to 60 mm with an axle hole of ø 12 mm, plastic forks (142 x 45 and 142 x 60 mm) and the DSF fork with adjustable shock absorber.
Measure the fork length, fork width and axle hole of your existing fork; the castor wheel will only fit if all three measurements match.
DSF front fork with adjustable shock absorber, black 131 x 40.5 mm, 3 ø8 mm holes
What the fork means for handling
The fork determines how high the front wheel sits and how far it runs from the pivot point. This sets the steering angle, which ensures the chair rolls straight ahead cleanly, even at a brisk pace. When the fork is vertical, a good front wheel can show its strengths fully.
What has to be measured
Three dimensions matter: the installed height from the wheel axle to the top edge of the steerer tube, the clear width between the fork legs, and the steerer tube diameter. Also consider whether several holes for height adjustment should be present; they allow you to change the front wheel later without replacing the fork.
When a change makes sense
When switching to a different front wheel size, as this keeps the seating angle of the whole chair intact. Also when a fork has been bent after an impact, recognisable by the wheel not standing vertically when stationary. And when the bearing seats have play and a new bearing no longer fits firmly, a new fork restores firm support.
Our tip
After every fork or front wheel change, check the steering angle: the steerer tube should stand vertically when stationary. Even a two-degree deviation makes a difference. With suitable forks and a correctly set angle, the chair runs calmly and true at speed.